Proper Gap For Shpwer Glass Doors

The gap from glass to glass where the strike side of the door meets the fixed panel at the vertical gap is normally 3 16.

Proper gap for shpwer glass doors.

It is 1 8 at the top and 3 8 at the bottom. I design frameless showers every day and install the complicated ones. The top of a knee wall will be made of glass. I think they did this to try and mask the gap.

The measurements should be to the nearest 1 16 inch. The standard tolerance for frameless shower glass is plus or minus 1 8. There are many variables that effect the gap you can achieve the 1st of them is the glass fabricator they cut the glass to one size and then polish it down to the finished size the standard for the industry is or 1 8 that a whopping 1 4. That s with floor to door top height of 7 feet.

Determine the distance from wall to wall at the top and bottom of the opening. I ve asked the contractor to replace it. Measure the opening height. This is the industry standard.

The glass was custom measured but when the door was installed the gap between the door and the adjacent glass isn t uniform. That way you can modify the fixed panel to accommodate the knee wall instead of trying to modify the door. The standard tolerance for frameless shower glass is plus or minus 1 8. If these differ select a door using the larger width for a bypass door or the smaller width for a pivot door.

We use 1 4 at the hinge side and 3 16 at the strike side. It s important to keep in mind the limitations of the fabricator and the installer. To my dismay there s a 1 2 inch space between the glass door and the adjoining glass attached to the wall as well as at the bottom of the door itself. Kitchen bath and glass.

This is the industry standard. The door guy said 24 inches is a good number depending of course on your ceiling height. Hinge side gap is 5 at the top 25 in the middle and 25 at the bottom. This is a new construction not an existing bathroom.

Also they put a plastic sweep along the edge. The gap from glass to glass where the strike side of the door meets the fixed panel at the vertical gap is normally 3 16. The gap you are showing is 3 8 that s about 1 8 to 3 16 above the accepted norm. If your shower includes a knee wall it is better to include in line panel in your design.

As the door is currently installed the strike side gap is 1 1 8 at the top 1 3 8 in the middle and 1 1 2 at the bottom. This doesn t seem unreasonable. It s important to keep in mind the limitations of the fabricator and the installer.